Operation Manual

237
Controls in detail
Power windows
왘 Remove the obstruction.
왘 Pull the respective door window switch
past the resistance point again and
release.
Stopping door windows during
Express-operation
왘 Press or pull the respective door
window switch again.
Synchronizing the door windows
The door windows must be resynchronized
앫 after the battery was disconnected
앫 if the door windows cannot be fully
opened (Express-open) or closed
(Express-close)
왘 Close all doors.
왘 Switch on the ignition (컄 page 40).
왘 Pull and hold switch 1, 2, 3, or 4
(
컄 page 236).
Once a door window is closed com-
pletely, hold the respective switch for
approximately 3 seconds.
The door window is synchronized.
Summer opening feature
If the weather is warm, you can ventilate
the vehicle before driving off by simulta-
neously:
앫 opening the door windows
앫 opening the tilt/sliding sunroof
앫 switching on the seat ventilation* for
the driver’s seat
i
If the upward movement of a door window is
blocked during the closing procedure, the door
window will stop and open slightly.
i
If the door window still does not close when
there is no obstruction, pull and hold the respec-
tive power window switch. The door window will
then close without the obstruction sensor
function.
i
Each door window must be resynchronized
separately.
컄컄