Operation Manual

R
if the camera lenses are dirty or covered.
Observe the notes on cleaning
(
Y page 363)
R
if the vehicle components in which the cam-
eras are installed are damaged. In this event,
have the camera position and setting checked
at a qualified specialist workshop
Do not use the 360° camera in this case. You
can otherwise injure others or cause damage to
objects or the vehicle.
The guide lines on the multimedia system show
the distances to your vehicle. The distances only
apply to road level.
The cameras in the front and in the rear area are
each protected by a flap. These flaps are opened
when the 360° camera is activated. Observe the
notes on cleaning (
Y page 363). For technical
reasons, the flaps may remain open briefly after
the 360° camera has been deactivated.
The field of vision and other functions of the
camera system may be restricted due to addi-
tional accessories on the rear of the vehicle (e.g.
license plate holder, bicycle rack).
On vehicles with height-adjustable chassis,
depending on technical conditions, leaving the
standard height can result in:
R
inaccuracies in the guide lines
R
inaccuracies in the display of generated
images (top view)
Activation conditions
The 360° camera image can be displayed if:
R
the multimedia system is switched on
R
the 360° Camera function is switched on
i
If the 360° camera is activated at speeds
above approximately 19 mph (30 km/h), a
warning message appears.
The warning message disappears if:
R
the vehicle's speed falls below approx-
imately 19 mph (30 km/h). The 360° cam-
era is then activated.
R
the message is confirmed with the %
button.
Switching the 360° camera on and off
using the button
X
To switch on: press button :.
Depending on whether position D or R is
engaged, the following is shown:
R
full screen display with the image from the
front camera
R
full screen display with the image from the
rear view camera
X
To switch off: press button : again.
Switching on the 360° camera and mul-
timedia system
X
Press the Ø button in the center console.
The vehicle menu is displayed.
X
To select the 360° camera: turn and press the
controller.
Depending on whether position D or R is
engaged, the following is shown:
R
a split screen with top view and the image
from the front camera or
R
a split screen with top view and the image
from the rear view camera
Activating the 360° camera using
reverse gear
The 360° camera images can be automatically
displayed by engaging reverse gear.
X
Make sure that the SmartKey is in position 2
in the ignition lock.
X
Make sure that the Activation by R gear
function is selected in the multimedia system
(see the separate operating instructions).
X
To show the 360° camera image: engage
reverse gear.
The multimedia system shows the area
behind the vehicle in split-screen mode. You
Driving systems
225
Driving and parking
Z