Operation Manual

R
Use only connector cables that are dry and
free of damage.
R
When the ignition is off, make sure that the
115 V power socket is dry.
R
Have the 115 V power socket checked or
replaced immediately at a qualified speci-
alized workshop if it is damaged or has been
pulled out of the trim.
R
Never plug the connector cable into a 115 V
power socket that is damaged or has been
pulled out of the trim.
G
DANGER
If you reach into the power socket or plug
inappropriate devices into the power socket,
you could receive an electric shock. There is a
risk of fatal injury.
Only connect appropriate devices to the
power socket.
!
Note that work and repairs on the 115 V
power socket should only be carried out by
qualified specialist personnel.
General notes
The 115 V power socket provides an alternating
voltage of 115 V so that small electronic devices
can be connected. These devices, such as
games consoles, chargers and laptops, must not
consume more than a maximum of 150 watts
altogether.
Requirements for operation of these devices:
R
the electronic device that you connect has a
suitable connector and conforms to stand-
ards specific to the country you are in.
R
the plug of the electronic device is plugged
correctly into 115 V power socket.
R
the maximum wattage of the device to be
connected must not exceed 150 watts.
R
the on-board power supply is within a permis-
sible voltage range.
R
the 12 V sockets in the center console in the
front compartment (
Y page 336) and in the
trunk are functional (
Y page 337).
Using the 115 V power socket
The 115 V socket is in the center console in the
rear compartment on vehicles with a rear bench
seat or electrically adjustable rear seats.
X
To switch on: switch the ignition on.
X
Open flap =.
X
Insert the plug of the electronic device into
115 V power socket :.
Indicator lamp ; lights up.
X
To switch off: remove the connector from
115 V socket :.
Ensure that you do not pull on the cord.
The 115 V socket is in the armrest on vehicles
with individual seats in the rear.
X
Open the armrest (Y page 327).
X
To switch on: switch the ignition on.
X
Open flap =.
X
Insert the plug of the electronic device into
115 V power socket :.
Indicator lamp ; lights up.
X
To switch off: remove the connector from
115 V socket :.
Ensure that you do not pull on the cord.
338
Features
Stowage and features