Operation Manual

Observe the following to make sure that the
automatic transmission stays in position N neu-
tral:
Operating with the SmartKey:
X
Make sure that the ignition is switched on.
X
Make sure that the vehicle is stationary.
X
Depress and hold the brake pedal.
X
Shift to neutral N.
X
Release the brake pedal.
X
Release the electric parking brake, if neces-
sary.
X
Switch off the ignition and leave the SmartKey
in the ignition lock.
Operating with the Start/Stop button:
X
Make sure that the ignition is switched on.
X
Make sure that the vehicle is stationary.
X
Depress and hold the brake pedal.
X
Engage park position P.
X
Release the brake pedal.
X
Remove Start/Stop button from ignition lock
(
Y page 162).
X
Insert the SmartKey into the ignition lock.
X
Switch on the ignition.
X
Depress and hold the brake pedal.
X
Shift to neutral N.
X
Release the brake pedal.
X
Release the electric parking brake, if neces-
sary.
X
Switch off the ignition and leave the SmartKey
in the ignition lock.
You can wash the vehicle in an automatic car
wash from the very start.
If the vehicle is very dirty, pre-wash it before
cleaning it in an automatic car wash.
After using an automatic car wash, wipe off wax
from the windshield and the wiper blades. This
will prevent smears and reduce wiping noises
caused by residue on the windshield.
Washing by hand
In some countries, washing by hand is only
allowed at specially equipped washing bays.
Observe the legal requirements in each country.
X
Do not use hot water and do not wash the
vehicle in direct sunlight.
X
Use a soft sponge to clean.
X
Use a mild cleaning agent, such as a car
shampoo approved by Mercedes-Benz.
X
Thoroughly hose down the vehicle with a gen-
tle jet of water.
X
Do not point the water jet directly towards the
air inlet.
X
Use plenty of water and rinse out the sponge
frequently.
X
Rinse the vehicle with clean water and dry
thoroughly with a chamois.
X
Do not let the cleaning agent dry on the paint-
work.
Carefully remove all deposits of road salt as
soon as possible when driving in winter.
Power washers
G
WARNING
The water jet from a circular jet nozzle (dirt
blasters) can cause invisible exterior damage
to the tires or chassis components. Compo-
nents damaged in this way may fail unexpect-
edly. There is a risk of an accident.
Do not use power washers with circular jet
nozzles to clean the vehicle. Have damaged
tires or chassis components replaced imme-
diately.
!
Always maintain a distance of at least
11.8 in (30 cm) between the vehicle and the
power washer nozzle. Information about the
correct distance is available from the equip-
ment manufacturer.
Move the power washer nozzle around when
cleaning your vehicle.
Do not aim directly at any of the following:
R
tires
R
door gaps, roof gaps, joints, etc.
R
electrical components
R
battery
R
connectors
R
lights
R
seals
R
trim
R
ventilation slots
Damaged seals or electrical components can
lead to leaks or failures.
360
Care
Maintenance and care