Operation Manual

Convenience closing feature
Important safety notes
G
WARNING
When the convenience closing feature is oper-
ating, parts of the body could become trapped
in the closing area of the side window and the
sliding sunroof. There is a risk of injury.
Observe the complete closing procedure
when the convenience closing feature is oper-
ating. Make sure that no body parts are in
close proximity during the closing procedure.
When you lock the vehicle, you can simultane-
ously:
R
close the side windows
R
close the panorama roof with power tilt/slid-
ing panel
On vehicles with a panorama roof with power
tilt/sliding panel, you can then close the roller
sunblinds.
i Notes on the automatic reversing feature
for:
R
the side window (Y page 94)
R
the panorama roof with power tilt/sliding
panel (
Y page 98)
R
the roller sunblinds (Y page 99)
Using the SmartKey
X
Press and hold the & button until the side
windows and the panorama roof with power
tilt/sliding panel are fully closed.
X
Make sure that all the side windows and the
panorama roof with power tilt/sliding panel
are closed.
X
On vehicles with a panorama roof with
power tilt/sliding panel: press and hold the
& button again until the roller sunblinds of
the panorama roof with power tilt/sliding
panel close.
X
To interrupt convenience closing: release
the & button.
Using KEYLESS-GO
The SmartKey must be outside the vehicle. All
the doors must be closed.
X
Touch recessed sensor surface : on the
door handle until the side windows and the
panorama roof with power tilt/sliding panel
are fully closed.
i
Make sure you only touch recessed sensor
surface :.
X
Make sure that all the side windows and the
panorama roof with power tilt/sliding panel
are closed.
X
Vehicles with a panorama roof with
power tilt/sliding panel: touch recessed
sensor surface : on the door handle again
until the roller sunblinds of the panorama roof
with power tilt/sliding panel close.
X
To interrupt convenience closing: release
recessed sensor surface : on the door han-
dle.
Resetting the side windows
If a side window can no longer be closed fully,
you must reset it.
X
Close all the doors.
X
Turn the SmartKey to position 1 or 2 in the
ignition lock.
X
Pull the corresponding switch on the door
control panel until the side window is com-
pletely closed (
Y page 95).
X
Hold the switch for an additional second.
If the side window opens again slightly:
X
Immediately pull the corresponding switch on
the door control panel until the side window is
completely closed (
Y page 95).
X
Hold the switch for an additional second.
X
If the respective side window remains closed
after the button is released, then it has been
set correctly. If this is not the case, repeat the
steps above.
96
Side windows
Opening and closing