Operation Manual

157
Controls in detail
Control system
If conditions have occurred causing status
messages to be recorded, the number of
messages appears in the right multifunc-
tion display:
1 Number of recorded status messages
왘 Press button k or j.
The stored messages will now be dis-
played in the order in which they have
occurred. For malfunction and warning
messages, see “Vehicle status messag-
es in the multifunction display”
(
컄 page 359).
Should the vehicle’s system record any
conditions while driving, the number of
messages will reappear in the multifunc-
tion display
앫 when the SmartKey in the starter
switch is turned to position 0 or
removed from the starter switch
or
앫 when you turn off the engine by press-
ing the KEYLESS-GO* start/stop
button on the gear selector lever once
and open the driver’s door (this puts
the starter switch in position 0, same
as with the SmartKey removed from
the starter switch)
Settings menu
In the
Settings menu there are two
functions:
앫 The function Reset , with which you can
reset most settings to those set at the
factory.
앫 A collection of submenus with which
you can make individual settings for
your vehicle.
The following settings and submenus are
available:
i
After you have scrolled through all recorded
status messages, the first recorded message
appears again.
i
The vehicle status message memory will be
cleared when you then turn the SmartKey in the
starter switch to position 1 or 2, or when you
press the KEYLESS-GO* start/stop button once
or twice without depressing the brake pedal. You
will then only see high priority messages in the
multifunction display (
컄 page 359).
Function Page
Resetting all settings 158
Submenus in the Settings menu 158
Instrument cluster submenu 160
Time submenu 161
Lighting submenu 163
Vehicle submenu 166
Convenience submenu 166