Operation Manual

163
Controls in detail
Control system
Lighting submenu
Access the
Lighting submenu via the
Settings menu. Use the Lighting sub-
menu to change the lamp and lighting set-
tings on your vehicle. The following
functions are available:
Setting daytime running lamp mode
(USA only)
왘 Move the selection marker with
button æ or ç to the
Lighting
submenu.
왘 Press button j or k repeatedly
until the message
Light Circuit
Headlamp Mode
appears in the multi-
function display.
The selection marker is on the current
setting.
왘 Press button æ or ç to select
manual operation (
Manual ) or daytime
running lamp mode (
Constant ).
With daytime running lamp mode activated
and the exterior lamp switch in
position M or U the low beam head-
lamps are switched on when the engine is
running.
In low ambient light conditions the follow-
ing lamps will switch on additionally:
앫 Parking lamps
앫 Tail lamps
앫 License plate lamps
앫 Side marker lamps
For more information on the daytime run-
ning lamp mode, see “Lighting”
(
컄 page 131).
Function Page
Setting daytime running lamp
mode (USA only)
163
Setting locator lighting 164
Setting night security illumina-
tion
164
Setting interior lighting delayed
switch-off
165
i
This function is not available in countries
where the daytime running lamp mode is manda-
tory and therefore in a constant mode.
i
For safety reasons, resetting to factory
settings (
컄 page 158) while driving will not
deactivate the daytime running lamp mode.
The following message appears in the multifunc-
tion display:
Cannot be fully reset to
factory settings while driving.