Operation Manual

203
Controls in detail
Power windows
Fully closing the door windows
(Express-close)
왘 Pull switch 1 or 2 past the resis-
tance point and release.
The corresponding door window closes
completely.
If the upward movement of the door win-
dow is blocked during the closing proce-
dure, the door window will stop and open
slightly.
Stopping windows
왘 Press or pull the respective switch
again.
Closing the windows with
KEYLESS-GO*
왘 Press and hold lock button on an out-
side door handle (
컄 page 66) until the
windows are closed.
Synchronizing power windows
The power windows must be synchronized
each time
앫 after the battery has been dis-
connected
앫 if the power windows cannot be fully
opened (Express-open) or closed
(Express-close)
Synchronizing the power windows
왘 Switch on the ignition (컄 page 40).
왘 Pull the power window switches until
the side windows are closed.
Hold the switches for approximately
1 second.
The power windows are synchronized.
Warning! G
Driver’s door only:
If within 5 seconds the switch is again
pulled past the resistance point and
released, the automatic reversal will not
operate.
Warning! G
When closing the windows make sure that
there is no danger of anyone being harmed
by the closing procedure.
The windows will not automatically re-open
if blocked during convenience closing.
If potential danger exists, proceed as
follows:
앫 Release the lock button.
앫 Pull on the door handle and hold firmly.
The side windows open for as long as
the door handle is held but the door not
opened.