Operation Manual

304
Operation
Tires and wheels
Restarting the Run Flat Indicator
The tire inflation pressure monitor must be
restarted in the following situations:
앫 if you have changed the tire inflation
pressure
앫 if you have replaced the wheels or tires
앫 if you have installed new wheels or
tires
왘 Using the Tire and Loading Information
placard on the driver’s door B-pillar or,
if available, the tire inflation pressure
label on the inside of the fuel filler flap,
make sure the tire inflation pressure of
all four tires is correct.
왘 Switch on the ignition (컄 page 40).
Make sure the standard display menu
appears in the multifunction display
(
컄 page 149).
왘 Press button k or j repeatedly
until the following message appears in
the multifunction display:
Run Flat Indicator
Active
Menu: R-Button
왘 Press the reset button (컄 page 27).
The following message will appear in
the multifunction display:
Restart
Run Flat Indicator?
Warning! G
The Run Flat Indicator does not provide a
warning for wrongly selected tire inflation
pressures. Always adjust tire inflation pres-
sure according to the Tire and Loading
Information placard on the driver’s door
B-pillar (
컄 page 295) or, if available, on the
tire inflation pressure label located on the
inside of the fuel filler flap (
컄 page 279).
The Run Flat Indicator does not replace
regular checks of the tire inflation pressures
since a gradual pressure loss in more than
one tire cannot be detected by the Run Flat
Indicator.
The Run Flat Indicator is not able to issue a
warning due to a sudden dramatic loss of
tire inflation pressure (e.g. tire blowout
caused by a foreign object). In this case
bring the vehicle to a halt by carefully apply-
ing the brakes and avoiding abrupt steering
maneuvers.
Warning! G
The Run Flat Indicator can only warn you in
a reliable manner if you have set the correct
tire inflation pressures for each tire.
If an incorrect tire inflation pressure was
set, the system will monitor the pressure ac-
cording to the incorrect value.