Operation Manual

308
Operation
Tires and wheels
왘 Switch on the ignition (컄 page 40).
왘 Press button è or ÿ on the mul-
tifunction steering wheel repeatedly
until the standard display menu
appears in the multifunction display
(
컄 page 149).
왘 Press button j or k repeatedly
until the following message appears in
the multifunction display:
Tire Pressure Monitor
Active
Menu: R-button
왘 Press the reset button (컄 page 27).
The following message will appear in
the multifunction display:
Restart tire
pressure monitor?
왘 Press button æ.
The following message will appear in
the multifunction display:
Tire Pressure Monitor
Restarted
After driving a few minutes the system
verifies that the current tire inflation
pressures are within the system’s
specified range. Afterwards the current
tire inflation pressures are accepted as
reference pressures and then moni-
tored.
If you wish to cancel activation:
왘 Press button ç.
Checking tire pressure electronically
with the Advanced Tire Pressure Moni-
toring System (Advanced TPMS)*,
(Canada only)
The TPMS only functions on wheels that
are equipped with the proper electronic
sensors. It monitors the tire inflation pres-
sure, as selected by the driver, in all four
tires. A warning is issued to alert you to a
decrease in pressure in one or more of the
tires.
Tire pressure inquiries are made using the
multifunction display. The present inflation
pressures are displayed only after a few
minutes’ travel time.
i
Reactivate the TPMS after adjusting the tire
inflation pressure to the inflation pressure rec-
ommended for the vehicle operating condition.
Tire pressure should only be adjusted on cold
tires. Observe the recommended tire inflation
pressure on the Tire and Loading Information
placard on the driver’s door B-pillar
(
컄 page 294). Some vehicles may have supple-
mental tire inflation pressure information for
driving at high speeds (
컄 page 301) or for vehi-
cle loads less than the maximum loaded vehicle
condition (
컄 page 301). If such information is
provided, it can be found on the inside of the fuel
filler flap.
i
This device complies with RSS-210 of In-
dustry Canada. Operation is subject to the fol-
lowing two conditions:
(1) This device may not cause interference, and
(2) this device must accept any interference
received, including interference that may
cause undesired operation of the device.
Any unauthorized modification to this device
could void the user’s authority to operate the
equipment.
컄컄