Operation Manual

Recalculating the route dynamically
The route types Dynamic Route and
Dynamic
Route Only After Request take
all relevant traffic messages into account
when calculating a route (
Y page 322).
If you have selected Dynamic Route
as the
route type, COMAND guides you to your des-
tination along the updated route.
If you have selected Dynamic Route Only
After Request as the route type, a prompt
will appear first.
You can now decide whether to:
R
accept the route suggested by COMAND
R
continue your original route
X
To accept the suggested route: press W
the COMAND controller.
X
To continue along the original route:
select Reject
by turning cVd the
COMAND controller and press W to con-
firm.
Destination memory
Home address (My Address)
Entering the home address via address
entry
X
Proceed as described under “Adopting an
address book entry as a home address”
(
Y page 362). Confirm My Address by
pressing W.
X
To enter the home address for the first
time: confirm New Entry
by pressing W.
X
To change the home address: select
Change
in the menu showing the home
address by turning cVd the COMAND con-
troller and press W to confirm.
X
Confirm New Entry by pressing W.
X
In both cases, enter the home address as a
destination, e.g. as a city, street and house
number (
Y page 325). Then, save the home
address (
Y page 329).
Adopting an address book entry as a
home address
X
To switch to navigation mode: press the
Ø button.
X
To show the menu: press W the COMAND
controller.
X
Select Destination in the navigation sys-
tem menu bar by turning cVd the
COMAND controller and press W to con-
firm.
X
Select From Memory and press W to con-
firm.
You will see the destination memory list
either with the character bar (option 1) or
as a selection list (option 2).
Option 1: destination memory list with
character bar
X
Slide VZ the COMAND controller repeat-
edly until the destination memory list
appears as a selection list.
Option 2: destination memory list as
selection list
362
Navigation
COMAND