Installation & Assembly

Package Contents
1of2
B
Lock Screw
x4
Inner Backplate
x1
A
Fixture Body
x1
White wire
from supply
White wire
from fixture
Black wire from
supply (or Red)
Black wire
from fixture
Ground wire
from supply
Ground wire
from fixture
Figure 2
STEP 2 - Wire Connections
A. Use standard wire connectors (not included) to make all wire
connections. (Connectors are not included with fixture.) Twist
connectors until wires are tightly joined together. Wrap each
connection with approved electrical tape and carefully stuff all the
connected wires between Inner Backplate (A) and Fixture Body (C).
STEP 1 Install Inner Backplate-
A. Pass the supply wires through
Inner Backplate (A). Attach Inner
Backplate (A) to Outlet Box with
the head of Green Ground Screw
facing you. Secure it with Outlet
Box Screws (not included).
Figure 1
Outlet Box
Outlet Box
Screw
A
STEP 3 - Install Fixture Body
A. Attach Fixture Body (C) over
Inner Backplate (A) and secure
with Lock Screws (B). Tighten
until snug with screwdrivers.
Your fixture is now assembled
and ready to use. Enjoy!
Figure 3
C
CAUTION FOR BULB REPLACING
When replacing bulbs, turn off power and allow lamp to cool. For safety
purpose, wear gloves and eye protection.
Flatheadscrewdriver, Phillips screwdriver,pliers,wirecutters,wirestrippers,electricaltape,safetyglasses.
Integrated18WLED
ToolsRequired:
EstimatedAssemblyTime:
Preparation:
20-30minutes
Identifyandinspectallpartsbeforebeginninginstallation.Checkpackagecontentlistanddiagramsbelowtobesureallpartsare
present.Ifanypartsaremissingordamaged,donotattempttoassemble,install,oroperatethefixture.Contactcustomerserviceforreplacement
parts.
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal. Do not subject
glass parts to any shock while in operation or shattering may result.
A
B
C
How To Replace Driver
A. Disconnect the fixture from the outlet box.
B. Unplug Driver wires from the Terminal Block by pressing the tabs on
the Terminal Block. Unlock Hex Nuts and Washers on the side of the
Driver and replace the Driver with a new one. Tighten the new Driver
with the previously removed Washers and Hex Nuts.
C. Block
Block
Connect the Live Wire from Driver to Port “L” on the Terminal ,
which is the corresponding port of the Live Wire from LED Panel.
Connect the Natural Wire from Driver to Port “N” on the Terminal
, which is the corresponding port of the Natural Wire from LED
Panel.
N
L
Live Wire from Driver Live Wire from LED Panel
Natural Wire from Driver Natural Wire from LED Panel
Terminal Block
D. Return to Step 2 to complete the installation of the fixture.
Hex Nut
Washer
Driver
Bolt
Terminal Block
Wires
Backplate
G
ND
Q
U
O
I
Z
E
L
Assembly Instruction