Service manual

STARTING SYSTEM SERVICE MANUAL NUMBER 26
Page 4A-20 90-861329--1 MARCH 1999
Armature Bearing (Commutator End)
REMOVAL
Use a universal puller plate, as shown, to remove bearing.
72068
a
b
a-Universal Puller Plate
b-Bearing
INSTALLATION
IMPORTANT: Brush holder must be installed on armature before installing armature
bearing.
Using the correct size driver, press on inner bearing race until it contacts shoulder of
armature shaft.
Gear Bearing
REMOVAL
Using the correct size driver, press bearing out of gear.
INSTALLATION
1. Using the correct size driver, press bearing into gear, from direction shown, to depth
specified.
72625
a
b
a-Depth - .011-.014 in. (0.28-0.38 mm)
b-Installation Direction
INDEX