Service manual

STARTING SYSTEM SERVICE MANUAL NUMBER 26
Page 4A-30 90-861329--1 MARCH 1999
Installation
IMPORTANT: Install special mounting shim (if equipped) between starter motor and
engine block.
1. Place starter motor in position and install mounting bolts. Torque bolts to 30 lb-ft (41 Nm).
2. Connect YELLOW/RED wire to terminal S of solenoid. Connect ORANGE wire, RED
wire, and battery cable to large terminal of solenoid. Tighten fasteners securely. Coat
terminals with Quicksilver Liquid Neoprene. Install battery cable boot, if so equipped.
3. Connect battery cables to battery in the following order. Connect positive (+) cable to
positive (+) battery terminal and tighten cable clamp. Then connect negative (–) cable
to negative (–) terminal and tighten clamp.
INDEX