Service manual

STARTING SYSTEM
SERVICE MANUAL NUMBER 26
90-861329--1 MARCH 1999 Page 4A-39
3. Install gear and drive over planetary shaft.
74087
a
b
c
Typical
a-Planetary Gear Shaft Assembly
b-Gear
c-Drive
4. Assemble drive on shaft assembly as follows:
a. Lubricate drive end of shaft assembly with SAE 10W oil.
b. Place gear over shaft.
c. Slide drive assembly onto shaft with pinion facing outward.
d. Slide retainer onto shaft with cupped surface facing end of shaft (away from pinion).
e. Position snap ring on upper end of shaft and hold in place with block of wood. Strike
wood block with hammer, thus forcing snap ring over end of shaft. Slide snap ring
down into groove.
72073
c
b
a
a-Snap Ring
b-Groove
c-Retainer
INDEX