Service manual

STARTING SYSTEM
SERVICE MANUAL NUMBER 26
90-861329--1 MARCH 1999 Page 4A-43
3. Momentarily touch a jumper lead from battery terminal to switch terminal. This shifts pin-
ion into cranking position where it will remain until battery is disconnected.
72629
4. Push pinion back toward commutator end to eliminate slack.
5. Measure distance between pinion and pinion retainer.
6. If clearance is not within limits of .010-.160 in. (0.25-4.00 mm), it may indicate excessive
wear of solenoid linkage, shift lever yoke, or improper assembly of shift lever mecha-
nism. Replace worn or defective parts, since no provision is made for adjusting pinion
clearance.
72077
a
b
c
a-Pinion
b-Retainer
c-Feeler Gauge
INDEX