Service manual

IGNITION SYSTEM SERVICE MANUAL NUMBER 26
Page 4B-10 90-861329--1 MARCH 1999
3. Start engine and run at idle speed until it reaches normal operating temperature.
70103
b
a
a
a-WHITE Leads
b-Jumper Lead
4. Install a jumper wire between the two WHITE leads on the distributor. Use Quicksilver
91-818812A1, or fabricate a jumper wire using a 6 in. (150 mm) section of 16 gauge wire
with two male bullet terminal ends connected.
5. Bypass the shift interrupt switch, as follows:
a. Disconnect wires at shift interrupt switch.
b. Temporarily join the engine harness wires
together.
75499
75552
IMPORTANT: Do not fail to reconnect these two wires to the shift interrupt switch
when timing procedures are complete.
Index