Service manual

IGNITION SYSTEM
SERVICE MANUAL NUMBER 26
90-861329--1 MARCH 1999 Page 4B-11
6. Aim timing light at timing tab, located on the timing gear cover and crankshaft torsional
damper. Check the timing. Refer to “Specifications.”
72328
73664
Typical
7. Adjust timing by loosening distributor clamp and rotating distributor body as required
until timing mark on damper or pulley lines up with the mark on tab specified in
“Specifications.” Tighten clamp and recheck location of timing mark.
8. Aim timing light at timing tab and recheck location of timing mark. Repeat Step 7 until
timing is correct.
9. Stop the engine. Torque distributor hold down bolt to 20 lb-ft (27 Nm).
10. Reconnect the two wires to the shift interrupt switch.
75499
75552
75553
Index