Service manual

WIRING DIAGRAMS

SERVICE MANUAL NUMBER 26

90-861329--1 MARCH 1999 Page 4E-9

Refer to gauge manufacturer’s instructions for specific connections.

NOTE:

Connect Wires Together with Screw and Hex Nut; Apply Liquid Neoprene to Con-

nection and Slide Rubber Sleeve over Connection.

NOTE:

Power for a Fused Accessory Panel May Be Taken from This Connection. Load

Must Not Exceed 40 Amps. Panel Ground Wire Must Be Connected to Instrument Terminal

That Has an 8-Gauge Black (Ground) Harness Wire Connected to it.

NOTE:

Lanyard stop switch lead and neutral safety switch leads must be soldered and

covered with shrink tube for a water proof connection. If an alternate method of connection

is made, verify connection is secure and sealed for a water proof connection.

a-Audio Warning Buzzer

b-Tachometer

c-Oil Pressure

d-Water Temperature

e-Battery Meter

f-Ignition Switch

g-Trim Indicator

h-Read/Observe NOTE 1 and 2.

i-Read/Observe NOTE 3.

j-To Engine Wiring Harness

Index