Service manual

WIRING DIAGRAMS SERVICE MANUAL NUMBER 26
Page 4E-10 90-861329--1 MARCH 1999
DUAL STATION USING A NEUTRAL SAFETY SWITCH IN ONLY ONE REMOTE CONTROL
50730
PRIMARY STATION
SECONDARY STATION
a
l
l
k
j
i
j
h
g
g
g
f
f
e
e
d
d
c
b
b
b
b
a-See Note 5
b-See Note 4
c-Start/Stop Panel
d-Water Temperature
e-Oil Pressure
f-Tachometer
g-Battery Meter
h-See Note 2
i-See Note 3
j-See Note 1
k-Extension Harness To Engine
l-Fuse
NOTE:
1
BROWN/WHITE wire is taped back at instrument end. If installing on boat that is
equipped with MerCruiser sterndrive, BROWN/WHITE wire is connected to the trim sender
terminal block. Also can be used for an accessory (limit 5 amps).
NOTE:
2
An accessory fuse panel may be connected at this location. The combined current
draw of the primary station and secondary station MUST NOT exceed 5 amps.
NOTE:
3
Tape back and insulate with at least four layers of electrical tape.
NOTE:
4
Connect wires together with screw and hex nut. Tighten securely and coat with Liq-
uid Neoprene to help control corrosion; when dry, slide neoprene sleeve over connection.
NOTE:
5
To WHT/GRN connection on terminal block at shift plate cutout switch.
Index