Service manual

MAINTENANCE
SERVICE MANUAL NUMBER 26
90-861329--1 MARCH 1999 Page 1B-17
9. Raise drive unit to full UP position.
10. Remove hose and flushing attachment.
CAUTION
If boat is in the water, seacock (water inlet valve), if equipped, must remain closed
until engine is to be restarted to prevent water from flowing back into cooling
system and/or boat. If boat is not fitted with a seacock, water inlet hose must be
disconnected and plugged to prevent water from flowing back into cooling system
and/or boat. As a precautionary measure, attach a tag to the ignition switch or
steering wheel of the boat with the warning that the seacock must be opened or the
water inlet hose reconnected prior to starting engine.
a. If equipped with seacock: Observing precaution above, open seacock.
b. If NOT equipped with seacock: Observing precaution above, remove plug from
seawater inlet hose and reconnect seawater inlet hose. Tighten hose clamps
securely.
Lubrication
Lubricate pivot points with SAE 30W motor oil and cable guide contact surfaces with
Quicksilver 2-4-C Marine Lubricant with Teflon.
Throttle Cable
75811
a
a-Pivot Points
Index