Service manual

SEAWATER COOLED MODELS
SERVICE MANUAL NUMBER 26
90-861329--1 MARCH 1999 Page 6A-13
3. Install fully-charged battery. Clean battery cable clamps and terminals and reconnect
cables (see CAUTION listed above). Tighten each cable clamp securely when connect-
ing.
4. Coat terminal connections with a battery terminal anti-corrosion agent.
5. Perform all maintenance tasks listed in the MAINTENANCE SCHEDULES, except
those performed during the power package lay up procedure.
6. Perform all checks in the BEFORE STARTING column of the Operation and Mainte-
nance Manual OPERATION CHART.
CAUTION
Refer to FLUSHING COOLING SYSTEM before starting engine.
7. Supply water to the seawater pickup pump as outlined in “Flushing Cooling System.”
8. Start engine and closely observe instrumentation to make sure that all systems are func-
tioning correctly.
9. Carefully inspect engine for fuel, oil, fluid, water and exhaust leaks.
10. Check steering system and shift and throttle controls for proper operation.
11. For drive unit, refer to appropriate sterndrive manual.
Index