Service manual

POWER STEERING PUMP
SERVICE MANUAL NUMBER 26
90-861329--1 MARCH 1999 Page 8A-3
Checking Power Steering Pump Fluid Level
IMPORTANT: Use only Quicksilver Power Trim and Steering Fluid, or automatic trans-
mission fluid (ATF), Dexron II, in power steering system.
With Cold Engine
1. Stop engine and position drive unit so that it is straight back.
2. Remove fill cap/dipstick from power steering pump and note fluid level.
75809
a
b
a-Fill Cap
b-Power Steering Pump
3. Level should be between “FULL COLD” mark and bottom of dipstick.
72519
a
a-Proper Fluid Level With Engine Cold
4. If fluid level is low but still visible in pump reservoir, add fluid through fill cap opening to
bring level up to “ COLD” mark on dipstick. Do not overfill.
Index