Service manual

POWER STEERING PUMP SERVICE MANUAL NUMBER 26
Page 8A-6 90-861329--1 MARCH 1999
Pump Pulley Replacement
REMOVAL
IMPORTANT: Kent-Moore Tool J-25034 must be used to remove the pressed-on
pulleys used on power steering pumps. This tool has an end on it that will not
mushroom the end of the pump shaft. DO NOT use Kent-Moore Tool J-21239 to
remove these pulleys. This tool has a tapered end and will damage the shaft.
1. Install Kent-Moore Tool J-25034 on end of pulley and shaft as shown.
2. While holding tool with suitable wrench, turn threaded screw until pulley is removed.
72821
a
a-Kent-Moore Pulley Removal Tool (J-25034)
INSTALLATION
Install pulley, as follows, using pulley installer tool (91-93656A1), and a long straight edge:
1. Place pulley on pump shaft.
2. Thread stud all the way into pump shaft. Place bearing over stud. Do not use spacer from
kit.
3. Thread nut onto shaft. Thread tool shaft (and nut) all the way onto stud (threaded into
pump pulley).
4. Using a long straight edge (to check drive belt alignment), turn large pusher nut until
drive belt is parallel to straight edge.
Index