Service manual

POWER STEERING PUMP

SERVICE MANUAL NUMBER 26

90-861329--1 MARCH 1999 Page 8A-13

INSTALLATION

CAUTION

Route hoses exactly as shown below. This will help avoid stress on the hose fittings

and will help avoid kinks in the hoses.

IMPORTANT: Be careful to not cross-thread or overtighten hose fittings.

1. Thread large fitting into control valve. Position hose properly (as prior to removal).

2. Torque fittings to 23 lb-ft (31 Nm).

73786

3. Route hose along flywheel housing and secure with J-clamp(s) provided.

4. Using hose clamp, install hose on fluid cooler. Tighten clamp securely.

73579

a-Fluid Cooler

b-Hose Clamp

c-Hose

5. Fill and air bleed system. Refer to SECTION 1B “Maintenance” (see “Table of Con-

tents”).

Index