Service manual

MCM 3.0L (181 CID) - ALPHA DRIVE SERVICE MANUAL NUMBER 26
Page 2A-12 90-861329--1 MARCH 1999
4. Relieve hoist tension entirely and fasten both front mounts to boat stringer using appro-
priate hardware (lag bolts or through-bolts, etc).
5. Recheck alignment with alignment tool. Tool must enter coupler splines freely. If not,
readjust front mounts.
6. When alignment is correct, tighten locknut or nut with lockwasher on each mount
securely.
22054
a
b
c
d
e
b
a-Front Mount
b-Attaching Bolts And Flat Washers
c-Adjustment Nut
d-Locknut
e-Jam Nut
7. Remove alignment tool if not already removed.
8. Tighten all exhaust system clamps securely as shown (use two clamps on each
connection).
50633
a
a-Hose Clamps
INDEX