User's Manual

Quantum 1000 Base Station User
For example to change the BS IP address to 192.168.2.113/24, then enter th
figure 61.
Figure
3)
The User is free to change the
SYSLOG Server Addr
(option #6). These will depend upon the Customer’s own network
configuration.
4)
Please note that you will not be able to change the
MAC Addr
(option #3) addresses.
5)
Hit the <ESC> to return to the
“Save” any changes.
6) Select 2 (
WIRELESS PROTOCOL
following two settings (figure
purposes.
•
UL Automatic TX Power Control
• Power C
ontrol Mode
Quantum 1000 Base Station User
Guide
Rev 1.1, Page
For example to change the BS IP address to 192.168.2.113/24, then enter th
e information as
Figure
61 - Base Station CLI IP Address Change
The User is free to change the
Default Gateway (option #3),
TFTP Server Addr
(option #6). These will depend upon the Customer’s own network
Please note that you will not be able to change the
Base Station ID
(option #1) and
(option #3) addresses.
Hit the <ESC> to return to the
1.1 BASIC CONFIGURATION
menu. You will be prompted to
WIRELESS PROTOCOL
) from the 1.1 BASIC CONFIGURATION
menu and verify the
following two settings (figure
62
). You cannot change the variables so this is simply for verification
UL Automatic TX Power Control
should be set to 1 (enabled)
ontrol Mode
should be set to 1 (Open-loop)
Rev 1.1, Page
54 of 70
e information as
(option #5), and
(option #6). These will depend upon the Customer’s own network
(option #1) and
Data Port
menu. You will be prompted to
menu and verify the
). You cannot change the variables so this is simply for verification