User's Manual Part 2

Quantum 1000 Base Station User
2)
Cut a length of the butyl such that it will completely cover the connection. Wrap the tape around
the connector and press into place. Ensure that there are no gaps
Figure
3)
Completely wrap the “wrapped assembly” with the larger 2 inch electrical (plastic) tape. Ensure
that the tape extends back up the cable to cover the entire
itself by approximately half a width (figure 5
Quantum 1000 Base Station User
Guide
Rev 1.1, Page
Cut a length of the butyl such that it will completely cover the connection. Wrap the tape around
the connector and press into place. Ensure that there are no gaps
(figures 52
and 5
Figure
52 - Butyl Tape Being Applied
Figure 53 - Butyl Tape Applied
Completely wrap the “wrapped assembly” with the larger 2 inch electrical (plastic) tape. Ensure
that the tape extends back up the cable to cover the entire
butyl tape and that the tape overlays
itself by approximately half a width (figure 5
4).
Rev 1.1, Page
48 of 70
Cut a length of the butyl such that it will completely cover the connection. Wrap the tape around
and 5
3).
Completely wrap the “wrapped assembly” with the larger 2 inch electrical (plastic) tape. Ensure
butyl tape and that the tape overlays