User's Manual

Quantum 1000 Base Station User
It is the intention of PureWave Networks to ensure that this equipment is tested to comply with the limits
for a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is
that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to c
• Re-
orient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which
connected.
•
Consult the dealer or an experienced radio/TV technician for help.
Shielded cables and I/O cords must be used for this equipment to comply with the relevant FCC
regulations.
Changes or modifications not expressly approved in
authority to operate this equipment.
Note:
This device must be professionally installed
Quantum 1000 Base Station User
Guide
Rev 1.1, Page
REGULATORY NOTICE
It is the intention of PureWave Networks to ensure that this equipment is tested to comply with the limits
for a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is
that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to c
orrect the interference by one or more of the following measures:
orient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is
Consult the dealer or an experienced radio/TV technician for help.
Shielded cables and I/O cords must be used for this equipment to comply with the relevant FCC
Changes or modifications not expressly approved in
writing by PureWave Networks may void the user's
authority to operate this equipment.
This device must be professionally installed
.
Rev 1.1, Page
3 of 70
It is the intention of PureWave Networks to ensure that this equipment is tested to comply with the limits
for a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is
no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and
orrect the interference by one or more of the following measures:
the receiver is
Shielded cables and I/O cords must be used for this equipment to comply with the relevant FCC
writing by PureWave Networks may void the user's