User's Guide

Quantum 2200 Installation Guide v2.1
Page 38
Appendix A Connector Weatherproofing
Required Materials
PureWave recommends that appropriate weather protection sealing be applied to all “outdoor”
installed elements of the system. Weatherproofing tape kits can very effectively seal the junction
between mating connectors. Proper and diligent weatherproofing not only protects the connection from
water damage, but also prevents vibrations from loosening the interface.
A wide range of weather protection materials and kits are commercially available. The PureWave
Quantum Basic DC Installation Kit and the Optional PureWave Quantum Surge Protection Kit each
include a weatherproofing kit that contains a variety of tapes along with general weatherproofing
guidelines.
General Guidelines for Working with Weatherproofing Tape
When applied, the tape must be above 32°F (0°C) to ensure adhesion.
Do not stretch the tape. Apply only enough tension to provide a smooth wrap.
Smooth each wrapped layer with your hands to ensure full adhesion.
Do not pull the tape to tear it - always cut it. Pulled tape eventually unravels, decreasing
protection.
Add extra final layers of tape in warmer climates where there will be long exposure to damaging
ultra violet (UV) rays. Two or three extra layers of tape will provide additional UV protection.
On vertical runs, the last wrap of 3/4” tape should be wrapped from the bottom to the top. This
provides a shingle effect.
When wrapping tape, overlap the tape to half-width as shown in Figure 32.
Figure 32: Proper Weatherproof Tape Overlap