Assembly Instructions ASSEMBLY RATING The Assembly Rating is a 5-point system that shows the degree of effort needed in assembling a specific product (with 1 being easy and 5 being difficult). For some products, two persons are recommended.
FOR YOUR FURNITURE TO LAST,CORRECT ASSEMBLY AND PROPER MAINTENANCE ARE NECESSARY. PLEASE FOLLOW THE INFORMATION PROVIDED BELOW TO FULLY ENJOY YOUR FURNITURE. BASIC ASSEMBLY TECHNIQUES When lock or spring washer is used in an assembly, please make sure the lock or spring washer is placed between the larger flat washer and the head of the screw or bolt. Some furniture comes with height adjusetment knobs underneath each leg.
Before you begin, please read Page 2 of "Assembly and Care Advice". And remember, do not tighten until each step is completed or instructed.
Prepare 6 bolts assembly by inserting lock washer (#B), then flat washer (#C) onto bolts (#A). Align headboard legs (#2R/L) to the holes of the headboard (#1). Secure with bolts (#A). #A x 6pcs #B x 6pcs #C x 6pcs #1 #2L #2R #C #A #B Hook the side rails (#4) to the latch of the headboard (#1) and footboard (#3). Make sure the side rails (#4) are on firmly.
#6 Attach 4 support legs (#7) to center rail (#6). Adjust floor protector according to ground level. #7 Align slats (#5) to the side rails (#4) and center rail (#6), then secure with screws (#E).
1. Prepare 6 bolt assemblies by first inserting a lock washer (#B) onto the bolt (#A) then a flat washer (#C) onto that same bolt (#A). 2. Align the legs (#2) to the holes along the side of the headboard (#1), then insert the bolts and secure. Hook each end of the side rails (#4) onto the slots along the headboard (#1) and foot board (#3).
Insert the threaded ends of the support legs (#7) into the holes along the center Adjust according rail (#6), turn right to tighten. to the ground level. Place the bed slats (#5) onto the rails, then insert a screw (#E) into each hole. Secure using a screwdriver.
Prepare 10 bolt assemblies by first inserting a lock washer (#B) onto the bolt (#A) then a flat washer (#F) onto that same bolt (#A). Insert into the holes. Secure.
