Installation Instructions

Installation Instructions for

1.2

Pendant

Place the shade and spacer over the socket, then secure them in place by tightening the collar nut.

Screw the lamp into the socket. Refer to the label on the lamp socket for Max Wattage information.

Follow enclosed supplement installation instructions for electrical and fixture installation onto house outlet box.

LAMP

SOCKET

SHADE

SPACER

COLLAR NUT

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed utilizing NEC compliant

junction boxes.

This product is safety listed for damp locations.

This product may be dimmed with a standard incandescent dimmer.

This instruction shows a typical installation.

CAUTION - RISK OF FIRE

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

1 Light Pendant

PAGE 1
Installation Instructions for 1 Light Pendant 1.2 Pendant GENERAL PRODUCT INFORMATION: These fixtures are intended to be installed utilizing NEC compliant junction boxes. CAUTION - RISK OF FIRE This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved. This product is safety listed for damp locations. This product may be dimmed with a standard incandescent dimmer.
PAGE 2
ATTENTION : RISQUE D'INCENDIE Ce produit doit être installé conformément au code d'installation en vigueur par une personne familière avec la construction et l'exploitation du produit et les risques qu'il entraîne. Utiliser les conducteurs d'alimentation supérieure à 90° c. 1A 3 DOUILLE ABAT-JOUR 1 ESPACEUR ECROU A COLLIER 2 AMPOULE 1 Placez l'abat-jour et l'espaceur sur la douille, puis fixez-les en place en serrant l'écrou du collier. 2 Vissez l'ampoule dans la douille.
PAGE 3
PRECAUCIÓN: RIESGO DE INCENDIO Este producto debe instalarse de acuerdo con el código de instalación aplicable por una persona familiarizada con la construcción y operación del producto y los riesgos que conllevan. Utilizar conductores de suministro mínimo 90° c. 1A 3 ENCHUFE PANTALLA 1 ESPACIADOR TUERCA DE COLLAR 2 BOMBILLA 1 Coloque la pantalla y el espaciador sobre el enchufe, luego fijarlos en su lugar apretando la tuerca de collar. 2 Enrosque la bombilla en el enchufe.