Assembly Instructions

PARTS DIAGRAM:
(2) Mounting bolts
(1) Mounting plate
(2) Canopy bolts
(3) Wire nuts
ASSEMBLY INSTRUCTIONS FOR
1.0
IMPORTANT SAFETY INSTRUCTIONS:
If you are unsure about what mounting method
you should use, please consult a qualified
professional or your local hardware store.
GENERAL PRODUCT INFORMATION:
This product is suitable
for dry locations only.
BULB TYPE: (1) 60Watt
Ceiling junction box
Canopy bolt
Neutral fixture wire
Hot fixture wire
Canopy
canopy nut
Shade A
Shade B
Socket Ring
Buld(Not included)
60Watt
Mounting plate
Mounting bolt
Ground wire
Wire nut
Bare copper wire
Tension wire fixture
1. Loosen the small screw on the tension wire fixture
and pull the tension wire through the canopy with
desired height then tighten the small screw.
2. Place the mounting plate over the center of the
ceiling junction box.
5. Attach the neutral fixture wire from the pendant to
the neutral junction box wire, fasten each together
with a wire nut and wrap the connection with
electrical tape; do the same way for hot fixture wire.
3. Align holes in mounting plate with holes in
junction box and attach with 2 mounting bolts
6. Gently tuck the wire connections neatly into the
ceiling junction box.
7. Push canopy assembly up over the mounting plate
until it is flush with the ceiling. Align holes in
canopy with canopy bolts in mounting plate and
secure with 2 canopy nuts.
8. Attach shade A and shade B to socket then screw
on socket ring to fix shades.
9. Install the bulb (Not Included) by screwing it into
the socket. Refer to the label on the lamp socket
for maximum wattage information.
4. Attach 2 ground wires (from lamp & junction box)
and bare copper wire, fasten each together with
wire nut and wrap the connection with electrical
tape.
N
N
L
L
a
b
c
d
PENDANT