Assembly Instructions

Open the carton and place all the parts onto a clean, non-marring surface.
Attach Back Legs(C) to Chair Seat(A) using Bolts(②) and Washers(③) with Allen Key(①).
Do not fully tighten the Bolts.
Step 3
Place the Chair on a LEVEL SURFACE to check for wobbles.
If it wobbles, apply steady and even pressure down on the Chair. This action should allow all of
the gaps to reach full alignment status.
When the Chair is level proceed to tighten all Bolts at all joints.
When tightening the Bolts, tighten sequentially.
DO NOT tighten any Bolt fully and then move on to the next one.
This could cause the frame to warp.
If the Chair is not stable it could lead to damage to the product.
Step 4
Place the Cushion(D) onto the Chair.
Your Chair is ready for use.
This Chair can only be used on a flat, level surface.
4 OF 5