Assembly Instructions

Place the Table on a LEVEL SURFACE to check for wobbles.
If it wobbles, apply steady and even pressure down on the Table Top. This action should allow all
of the gaps to reach full alignment status.
When the Table is level proceed to tighten all Bolts at all joints.
When tightening the Bolts, tighten sequentially.
DO NOT tighten any Bolt fully and then move on to the next one.
This could cause the frame to warp.
If the Table is not stable it could lead to damage to the product.
Step 3
Your Table is ready for use.
This Table can only be used on a flat, level surface.
Open the carton and place all the parts onto a clean, non-marring surface.
Place the Table Top(A) facedown.
Attach Legs(B) to Table Top(A) using Bolts(②), and Washers(③) with Allen Key(①).
Do not fully tighten the Bolts.
Step 2
3 OF 4