Assembly Instructions

Table Of Contents

ASSEMBLY INSTRUCTIONS

Wrench

Parts List

Pieces

Schema

Description

QTY

Screw

Flat washer

Lock washer

Nut

Alu plate

(M8 *45)

(M8 )

Factory

already

assembled

Seat

Base

Seat Cushion

Made in China

1. Please read these instructions carefully before assembly.

2. Since aluminum is soft metal over tightening may strip thread or break the part.

3. DO NOT use power tools.

4. Check parts against the parts list to make sure you have all parts needed for

proper assembly.

5.Familiarize yourself with the inventory of parts and the accompanying illustrations

to ensure safe and proper assembly.

ATTENTION:ATTENTION:

This chair has a 300 lbs weight capacity.

WARNING!WARNING!

Back Cushion

PE cap

If cushion gets wet, hang over chair to dry to prevent mold/mildew.

PAGE 1
ASSEMBLY INSTRUCTIONS L J Parts List Pieces A B C D Schema (M8 *45) Description (M8 ) Screw Flat washer (M8 ) Lock washer (M8 ) Nut F Alu plate G Wrench H PE cap QTY 4 4 4 4 2 1 Factory already assembled K I Seat J Base I 1 H 1 WARNING! K Seat Cushion 1 Back Cushion 1 This chair has a 300 lbs weight capacity. If cushion gets wet, hang over chair to dry to prevent mold/mildew. ATTENTION: L 1. 2. 3. 4. Please read these instructions carefully before assembly.
PAGE 2
1. Remove all protective packing material and position base on floor. Attach the seat(I) onto the base(J) with Alu plate(F) as the picture, then assemble using bolt(A), flat washers(B),lock washers(C),nuts(D) and nut cap(E). Be sure the arrows face the front. 2. Tighten all the bolts and nuts. Test the swivel rocker gently. If the rocker does not rock properly, double check the assembly procedure. 3.Put Cushion(K) on the unit(as shown in the picture).