Installation & Assembly

Table Of Contents

Part Needed Quantity

Reason why ( missing, scratched, broken glass, bent, bad finish)

Comments

2ea 5/32-IP*H3mm

This fixture assembled PO:__________ Date: ________

Notice:

Please review the parts listing and check for all parts before assembling the fixture. If any parts are missing

or damaged, please note onthis sheet and contact the place of purchase to arrange for replacement parts.

PARTS LIST

Company Name:_______________________Co. Account #:_____________

Mounting Strap Mounting screws

3ea P3 Orange 2ea 5/32-IP*1-1/2"

For Customer Service, contact the place of purchase to arrange for replacement parts.

FIXTURE ASSEMBLY INSTRUCTIONS

Read and review installation instruction sheet, but

do not install before assembling the fixture.

1. Slide the Glass (J) over the Socket (I)

2. Install the light bulb in accordance with the

fixture's specifications.

(DO NOT EXCEED MAXIMUM WATTAGE RATING)

Fig 1

NOTE: INSTALL THE GLASS ASSEMBLY AFTER

THE FIXTURE IS HUNG.

PARTS & ASSEMBLY SHEET

Deco nut

Wire connectors Mounting screws Hex nut

1ea

∅

4"*H2mm 2ea 8#32-IP*1" 2ea 5/32-IP*H9mm

to be filled out by retailer

PAGE 1
PARTS & ASSEMBLY SHEET This fixture assembled PO:__________ Date: ________ Notice: Please review the parts listing and check for all parts before assembling the fixture. If any parts are missing or damaged, please note onthis sheet and contact the place of purchase to arrange for replacement parts. PARTS LIST Company Name:_______________________Co.
PAGE 2
INSTALLATION INSTRUCTIONS For Wall Mount Light Fixture WARNING ! SHUT OFF POWER AT FUSE OR CIRCUIT BREAKER. HANGING THE FIXTURE (Fig. 1) 1. Carefully remove the new fixture from the carton and the yellow bag that holds all your parts. Check that all parts are included as shown in the illustration and parts list. 2. Shut off power at the circuit breaker and remove the old fixture from wall, including the old mounting strap. 3. The Mounting Strap (C) contains several pairs of threaded holes.