- Ford Motor Company 1999 Mercury Villager Owner's Guide

• The hand-held transmitter appears to program the HomeLinkt

Universal Transceiver but does not activate the device.

• Press and hold the trained HomeLinkt button. The device has the

rolling code feature if the indicator light flashes rapidly and then turns

solid after 2 seconds.

After completing the “Programming” functions, follow these steps to

train a garage door opener with the rolling code feature:

1. Locate the training button on the garage door motor head unit.

Refer to the garage door opener manual or call 1–800–355–3515 or on

the Internet at HomeLink.jci.com. if there is difficulty locating the

training button.

2. Press the training button on the garage door motor head unit (which

will activate the “training” light.)

3. Press and release the

programmed HomeLinkt button.

Press and release the HomeLinkt

button a second time to complete

the training process. (Some garage

door openers may require this

procedure to be done a third time

to complete the training).

The 2nd or 3rd press from step 3 will activate the door. The HomeLinkt

Universal Transceiver has now been trained to the receiver. The

remaining two buttons may now be programmed if this has not

previously been done.

Erasing HomeLinkT buttons

Individual buttons cannot be erased,

however, to erase the three

programmed buttons:

1. Hold down the two outside

buttons until the red light begins to

flash after 20 seconds.

2. Release both buttons.

Reprogramming a single HomeLink

button

To program a device to HomeLinkt using a HomeLinkt button previously

trained, follow these steps:

REC DEL PLAY

Controls and features