Owner`s manual

FUEL & OIL
24
IMPORTANT: Oil must be NMMA certified TC‑W3 2‑Cycle oil.
Mercury or Quicksilver Premium TC‑W3 2‑Cycle oil is recommended for this engine. For added protection and
lubrication, Mercury or Quicksilver Premium Plus TC‑W3 2‑Cycle oil is recommended. If Mercury or Quicksilver
outboard oil is not available, substitute another brand of 2‑cycle outboard oil that is NMMA Certified TC‑W3. Severe
engine damage may result from use of an inferior oil.
Fuel and Oil Ratio
MODELS WITH OIL INJECTION
Use a 50:1 (2%) gasoline/oil mixture in the first tank of fuel. Follow the table below for mixing ratios. Use of this
fuel mixture combined with oil from the oil injection system will supply adequate lubrication during engine break‑in.
After the break‑in fuel mixture is used up, it is no longer necessary to add oil with the gasoline.
NOTE: At the end of the break‑in period, visually check to see if the oil level in the oil injection system has dropped.
Oil usage indicates the oil injection system is functioning correctly.
GASOLINE/OIL MIXING RATIO CHART
Gas/Oil Ratio 3.8 liters (1 gal.) gas 11.5 liters (3 gal.) gas 23 liters (6 gal.) gas
50:1 (2%) 89 ml (3 fl. oz.) oil 237 ml (8 fl. oz.) oil 473 ml (16 fl. oz.) oil
MODELS WITHOUT OIL INJECTION
Use a 25:1 (4%) gasoline/oil mixture in the first tank of fuel.
After the break‑in fuel mixture is used up, use a 50:1 (2%) gasoline/oil mixture. Follow the table for mixing ratios.
GASOLINE/OIL MIXING RATIO CHART
Gas/Oil Ratio 3.8 liters (1 gal.) gas 11.5 liters (3 gal.) gas 23 liters (6 gal.) gas
25:1 (4%) 148 ml (5 fl. oz.) oil 473 ml (16 fl. oz.) oil 946 ml (32 fl. oz.) oil
50:1 (2%) 89 ml (3 fl. oz.) oil 237 ml (8 fl. oz.) oil 473 ml (16 fl. oz.) oil
Filling Oil Injection System
1. Check oil level using the sight gauge in front of the outboard.
2. Remove the fill cap and fill tank with oil.
Capacity Fluid Type
Oil tank 3.2 liters (96 fl. oz.)
Mercury or Quicksilver Premium 2‑cycle TC‑W3
outboard oil