Owner`s manual

OPERATION

3030

a - Fast idle speed lever b - Throttle only feature

b. Manual start models ‑ Depress fuel primer rapidly 4 to 6 times.

NOTE: For initial start of a new engine or first start after a prolonged storage, air may be present in primer. If this

is the case, primer several times until fluid can be felt and then the normal 4 to 6 times.

3076

10. Starting a flooded engine:

a. Tiller handle models ‑ Advance the throttle grip to full throttle speed. Without activating primer, start

engine following starting procedure. Immediately start to reduce engine speed after engine starts.

b. Remote control models ‑ Advance the fast idle speed lever or throttle only feature to the full maximum

position. Without activating the primer, crank engine for 10 seconds. Wait 30 seconds and repeat until

engine starts. Immediately start to reduce engine speed after engine starts.

11. Turn ignition key to "START" position and start the engine. If engine is cold, push in on key to prime the

engine while cranking. If engine fails to start in ten seconds, wait 30 seconds and try again. If engine begins

to stall, reprime until engine is running smoothly.

ob00354

WARNING

RAPID ACCELERATION HAZARD ‑ Tiller Handle Models ‑ Before shifting your outboard from neutral into

gear, decrease engine speed to slow. This will prevent a rapid acceleration that can cause people in the boat

to be thrown from their seats or out of the boat, causing injury or death.

12. Manual start models ‑ Pull starter rope.