Specifications

FEATURES AND CONTROLS
60 eng
ENGINE GUARDIAN SYSTEM
The Engine Guardian system monitors the critical sensors on the
engine for any early indications of problems. Engine Guardian is
functional whenever your engine is operating, so you never have
to be concerned about whether or not you are protected. The
system will respond to a problem by sounding the warning horn
for six seconds and/or reducing engine power in order to provide
engine protection.
If Engine Guardian has been activated, reduce the engine
speed. The problem will need to be identified and corrected. The
system must be reset before the engine will operate at higher
speeds. Moving the throttle lever back to the idle position will
reset the Engine Guardian system. If the Engine Guardian
system has determined the reset has not corrected the problem,
Engine Guardian will remain activated, limiting the throttle. The
problem must be identified and corrected before Engine
Guardian will allow the engine to reach a normal operating RPM.
OVERSPEED REV LIMIT
The overspeed rev limit is set at an RPM greater than the
operating range. In the event that the engine is operated at an
RPM greater than or equal to the overspeed limit, the PCM does
not allow the engine to maintain the power requested by the
operator. Refer to Specifications to determine this engine’s
RPM limit.
Upon reaching the beginning of the rev limit, Engine Guardian
will cut‑out the ignition to specific cylinders. If the operator does
not reduce engine speed, Engine Guardian will cut‑out the
ignition to all the cylinders. There is no audible warning while
Engine Guardian overspeed limit is active.
To reset the Engine Guardian protection:
1. Completely reduce the throttle for three seconds.
2. Engage the throttle. If the engine does not respond, repeat
step one.