Specifications

MAINTENANCE
88 eng
Fuses
IMPORTANT: Always carry spare 2‑, 15‑, and 20‑amp fuses.
The electrical wiring circuits on the engine are protected from
overload by fuses in the wiring. If a fuse is blown, try to locate
and correct the cause of the overload before replacing the fuse.
If the cause is not found, the fuse may blow again.
1. Open the fuse holder and look at the silver colored band
inside the fuse. If the band is broken, replace the fuse.
2. Replace fuse with a new fuse with the same rating.
The fuses and circuits are identified as follows:
Fuse location and identification
a - Good fuse
b - Blown fuse
c - Power‑on circuit – 15‑amp fuse
d - Ignition coil circuit – 20‑amp fuse
e - Spare fuse slot
f - Fuel injector/direct injector/PCM and electric fuel pump
circuits – 20‑amp fuse
g - Diagnostic circuit – 2‑amp fuse