Specifications

FEATURES AND CONTROLS
eng 91
Synchronizing Helms Prior to Transfer
Pressing the "TRANSFER" button allows the boat operator 10
seconds to match up the control handle settings at the new helm
with the handle settings that are at the old (to be inactive) helm.
If the handles are not matched, the neutral lights will flash. The
light blinks faster as the handles are nearing match position.
Once the light stays on continuously, the handles are matched
and the button can be pressed again to complete the transfer.
This completes the transfer process, and gives control to the
new station. If the helm transfer is not completed within 10
seconds, the action will be cancelled.
Warning System
WARNING HORN SIGNALS
When the key switch is turned to the "ON" position, the horn
(located on the command module harness) will turn on for a
moment as a test to indicate the horn is working.
There are two types of warning horns to alert the operator of an
active problem within the engine’s operating system.
1.
Continuous six second beep: Indicates a critical engine
condition. Depending on the condition, the Engine Guardian
System may engage and protect the engine by limiting it’s
power. You should return to port immediately and contact
your servicing dealer.
2.
Intermittent short beeps for six seconds: Indicates a
noncritical engine condition. This condition does not require
immediate attention. You may continue using your boat,
however, depending on the nature of the problem, the
engine’s power may be limited by the Engine Guardian
System (see Engine Guardian System following) to protect
the engine. You should contact your servicing dealer at your
earliest convenience.