Specifications

OPERATION
eng 101
4. Set the lanyard stop switch to the "RUN" position. Refer to
General Information ‑ Lanyard Stop Switch.
19791
5. Shift outboard to neutral (N) position.
F
N
R
3413
F
N
R
3417
NOTE: For initial start of a new engine or for an engine that ran
out of fuel or was drained of fuel, the fuel system should be filled
as follows:
Turn the ignition key switch to the "ON" position for
approximately one minute. This operates the fuel lift pump. Turn
the ignition key switch back to the "OFF" position and then
return the ignition key switch to the "ON" position again for an
additional minute. Turn the ignition key switch back to the "OFF"
position. The filling of the fuel system is complete.