Specifications

OPERATION
102 eng
6. Ignition key starting ‑ Turn the ignition key to "START"
position and release the key. The electronic starting system
will automatically crank the engine for starting. If the engine
fails to start, the engine will stop cranking. Turn the key to
"START" position again until engine starts.
S
T
A
R
T
O
F
F
A
C C
O
N
S
T
A
R
T
O
F
F
A
C
C
O
N
3485
7. After engine starts, check for a steady stream of water
flowing out of the water pump indicator hole.
IMPORTANT: If no water is coming out of the water pump
indicator hole, stop engine and check the cooling water intake
for obstruction. No obstruction may indicate a water pump
failure or blockage in the cooling system. These conditions will
cause the engine to overheat. Have the outboard checked by
your dealer. Operating the engine while overheated will cause
engine damage.
Gear Shifting
DTS PANEL MOUNT REMOTE CONTROL
IMPORTANT: Never shift outboard into gear unless engine
speed is at idle. Do not shift outboard into forward or reverse
when the engine is not running.