Specifications

MAINTENANCE
110 eng
5. When flushing is complete, turn off water and disconnect the
water hose.
6. Install the flushing connector to the fitting on the bottom
cowl. Tighten the connector securely.
Cowl Removal and Installation
COWL REMOVAL
IMPORTANT: Most maintenance points are accessible by
removing the top cowl only.
1. Pull up on the top cowl lock latch.
28946
2. Pull top cowl forward and lift off.
3. Pull lower cowl release latch up.
4. Remove rear cowl towards aft of outboard.
28770
COWL INSTALLATION
1. Position lower cowl from aft side of outboard. Make sure it
fits properly in the rubber seal.