Specifications

MAINTENANCE

128 eng

8. Before installing spark plugs, clean off any dirt on the spark

plug seats. Install plugs finger‑tight, and then tighten 1/4 turn

or torque to specifications.

Description Nm lb. in. lb. ft.

Spark plug 27 20

9. Push pencil coils into place over the spark plugs using a

twisting motion.

10.Secure coils with retained bolts. Torque to specifications.

Description Nm lb. in. lb. ft.

Bolts 8 71

11.Connect the six wiring harness connectors to pencil coil

connections.

a - Wiring harness connector

b - Pencil coil

c - Bolt

12.Reinstall rear and top cowls.

Fuses

The electrical wiring circuits on the outboard are protected from

overload by fuses in the wiring. If a fuse is blown, try to locate

and correct the cause of the overload. If the cause is not found,

the fuse may blow again.

Remove the fuse puller from the holder.

3658