Specifications

MAINTENANCE
130 eng
DTS Wiring System
!
WARNING
Splicing or probing will damage the wire insulation allowing
water to enter the wiring. Water intrusion may lead to wiring
failure and loss of throttle and shift control. To avoid the
possibility of serious injury or death from loss of boat control,
do not splice or probe into any wire insulation of the DTS
system.
• Verify the harnesses are not routed near sharp edges, hot
surfaces, or moving parts.
• Verify all unused connectors and receptacles are covered
with a weather cap.
• Verify the harnesses are fastened along the routing path.
Accessory Drive Belt Inspection
Inspect the accessory drive belt and have it replaced by an
authorized dealer if any of the following conditions are found.
• Cracks in the back of the belt or in the base of V grooves.
• Excessive wear at the roots of the grooves.
• Rubber portion swollen by oil.
• Belt surfaces roughened.
• Signs of wear on edges or outer surfaces of belt.
Checking Power Trim Fluid
1. Tilt outboard to the full up position.
2. Rotate the tilt support bracket down.
3. Lower outboard until tilt support bracket rests on pedestal.