Specifications

MAINTENANCE
eng 133
IMPORTANT: The pump method is preferred to remove engine
oil from XXL models. If the drain method is used, an oil drain
funnel must be used to divert oil from the lower splash plate and
into the container.
1. Tilt the outboard out/up past vertical for approximately one
minute to allow any trapped oil to drain back to the oil sump.
2. Place the outboard in a vertical position.
3. Remove the dipstick and slide the adapter tube of the
crankcase oil pump through the oil dipstick hole, to the
bottom of the engine oil sump.
4. Pump out the engine oil into an appropriate container.
Crankcase Oil Pump
91‑90265A 5
11591
Aids in the removal of engine
oil without draining the
crankcase.
DRAIN METHOD
1. Tilt the outboard out/up past vertical for approximately one
minute to allow any trapped oil to drain back to the oil sump.
2. Place the outboard in a vertical position.
3. Place an appropriate container under the engine oil sump
plug. The drain plug/seal washer is located beneath the
splash plate on the port side of the outboard.