Owner`s manual

OPERATION
51
The active light is illuminated at the remote control station that is in control of the engine.
!
WARNING
Avoid serious injury or death from loss of boat control. The boat operator should never leave the active
station while engine is in gear. Helm transfer should only be attempted while both stations are manned.
One person helm transfer should only be performed while engine is in neutral.
NOTE: Idle position is preferred when doing a station transfer. If conditions do not allow the remote
control to be placed at idle position, a station transfer can be done while in gear.
NOTE: Pressing and releasing station select button at new station allows the engine control to be
transferred to the new station. The control will automatically start adjusting engine RPM and gear position
to match the control handle setting at the new station. Adjust control handles to the desired throttle and
gear position.
1. Place active remote control lever to idle position.
2. Proceed to the inactive helm station and position remote control lever to the idle position.
3. Press throttle only/station select button once. The "ACTIVE" light will illuminate to indicate the
remote control station is in control of the engine.
ACTIVE
STATION SELECT
3433
ACTIVE
SYNC
STATION SELECT
a
a
b
THROTTLE
ONLY
THROTTLE
ONLY
b
a - Active light b - Throttle only/station select button
4. The active light will switch off at the original remote control station.
SYNCHRONIZING DUAL HELMS PRIOR TO STATION TRANSFER
Pressing the station select button and holding it in allows the boat operator 10 seconds to match up the
control handle settings at the new station with the handle settings that are at the old (to be inactive)
station. If the handles are not matched, the neutral light will flash. The light blinks faster as the handles
are nearing match position. Once the light stays on continuously, the handles are matched and the button
can be released. Transfer process is complete and the new station is now in control. If the button is held
for over 10 seconds, the station transfer is cancelled.
Synchronizing Dual Engines
The auto synchronizing feature, when engaged, will automatically adjust the port engine speed to match
the speed of the starboard engine.
Synchronizing of engines will automatically engage when the speed of both engines are over 900 RPM
for two seconds and remote control handles are positioned within 5° of each other.
Auto Synchronizing will stay engaged up to 95% throttle opening. The Sync light will turn on when the
engines are synchronized.